Plastic Body Jet Water Pump

INSTALLATIONS AND USE

.For domestic water supply

.For drawing water out of a well

.For lifting water containing air

.For increasing water pressure  from flooded suction applications

.As pressure boosting pump for central water systems with low pressure

.For garden use

.The pump should be installed in an enclosed environment or sheltered from inclement weather

PERFORMANCE RANGE

.Flow rate  up to 85l/min

.Head up to65m

OPERATING  CONDITIONS

.Liquid temperature  up to + 35℃

.Ambient temperature up to+40℃

.Max. Working  pressure 10bar

.Continuous duty

OPTIONS AVAILABLE ON REQUEST

.Special mechanical seal

.Other voltages or 60Hz frequency

.Higher or lower liquid temperatures

ELECTRIC MOTOR

.Two- pole induction motor, 50Hz(n=2850rpm)

.Single phase 220V-240V

.Three phase 380V-415V

.Thermal  protector incorporated into the winding

.Insulation class F

.Protection IP44

COMPONENT MATERIALS

Pump body      Cast iron with an Electro Coating

Diffuser         PPO

Impeller        Brass

Support         Cast  iron  with an Electro Coating  Aluminum on request

Motor case        Aluminum

Shaft             Stainless steel AISI 304

Mechanical seal       Carbon -Ceramic -NBR